Land Clearing in Maryville, TN

Maryville ground: valley clay to foothill grades

Maryville sits in the foothills of the Great Smoky Mountains at roughly 980 feet, with Chilhowee Mountain, the outermost ridge of the western Smokies, rising to the south. Blount County stretches from TVA lakes on its west side to the national park on its east, so a lot can be level pasture toward Alcoa or a wooded grade off US 321 on the way to Townsend. Pistol Creek winds through town on its way to the Little River, and smaller branches cross plenty of residential parcels.

The valley floors share the Ridge-and-Valley pattern found around Knoxville: clay over limestone and dolomite, oak and hickory on the wooded slopes, cedar in old fields. Slope decides the method. A tracked mulcher holds a grade that a wheeled machine cannot, and a pad on a hillside is benched in, with silt fence along the downhill edge before the soil is opened.

Growth around Maryville and Alcoa

Maryville's population went from 27,465 in 2010 to 31,907 in 2020, an increase of about 16 percent. Alcoa, its twin city to the north, and the US 129 corridor tie both cities to Knoxville. On the ground, growth shows up as infill lots inside the city, subdivision lots that sat long enough to grow back, and acreage outside town being split into home sites.

Each starts differently. An infill lot is usually tree and stump removal plus brush removal. A grown-over subdivision lot gets a forestry mulching pass if it is being sold as is, or full lot clearing if a house is going in now. Acreage being divided often needs a drive corridor and building sites opened first, with the rest mulched, and boundary lines fall under fence line clearing.

Maryville's grading permit and the state rule

Inside city limits, Maryville's Engineering and Public Works Department handles grading permits. The city asks for an erosion prevention and sediment control plan when land disturbance reaches one acre, and a simpler sketch plan for land-disturbing work between 0.10 and 1 acre. At an acre or more, the state's construction stormwater general permit applies as well, and the city will not issue the grading permit until TDEC's Notice of Coverage, the Notice of Intent and the stormwater pollution prevention plan accompany the plan.

Outside the city, check with Blount County before work starts. Anywhere in the county, clearing in or along a creek can need TDEC's Aquatic Resource Alteration Permit, and silt fence and stabilization are part of the job, not an extra.

What clearing costs in Maryville

A Maryville quote depends on slope, undergrowth density, tree size, how near a truck can park, and whether material stays on site as mulch or leaves on a trailer. A benched pad on a hillside also adds grading to the scope. The cost page lists typical ranges by service, and cost to clear an acre covers the per-acre view. Your number comes in writing after the walk.

Have a Maryville lot walked

Call (865) 622-5131, give the address, and say what you want the land to be when the work is done. Or request a callback and we will call you.

Other areas we serve

• Knoxville
• Oak Ridge
• Farragut
• Powell
• Clinton
• Lenoir City
• Sevierville